| previous by date | index | next by date |
| topic list | next in topic |
Hi everyone,
This is my first post here. So, I've had my Mono/Poly for over a year now and everything worked perfectly until yesterday, when, out of the blue the tuning went sharp by a half step. I have the Tubbutec modypoly upgrade and was sending MIDI via my Digitone, recording onto a four-trape tape recorder. I don't know if this is connected (very much doubt it), but I was trying to change the clock divider via MIDI CC, but I think I did something wrong, as it didn't work. And then the channel on my four-track that was receiving audio from my Mono/Poly cut out. Turned the synth on and off, still no sound. I did a "factory reset" of the synth as outlined in the Tubbutec manual, and after that the machine was playing half a step sharp.
Any ideas what could be going on here? I'm not at all tech-y, so I can't run any checks or diagnostics. Obviously, I can compensate by adjusting the master tuning accordingly, but I'm concerned that there could be a bigger problem here. Any help/suggestions would be greatly appreciated.
Thanks.
Phil