| previous by date | index | next by date |
| previous in topic | topic list | next in topic |
As an update, I was able to spray some control cleaner into the guts of the mod pots (after removing their 4 screws and back plates) and their performance improved. It was a relief not to replace anything!
My next question, a long shot: does anyone want to part with a wooden lid for the 200, or have an extra one for some reason? Mine was lost by a previous owner.
I just acquired an Electrocomp 200 with scratchy pots, and am looking for advice. The Allen-Bradley type J pots are fine, but the square cermet "mod pots" (modular potentiometers) did not survive the last few decades and can't be repaired because of the way they're constructed. For the ones that are just a single value I'm replacing them with other pots, but the problem is the two filter cutoff frequency controls, where a single shaft simultaneously turns two pots of different values (100k and 1meg). I can't find any new old stock, and to have replacements custom manufactured by potentiometer.com would cost $45 each with a $50 low volume fee and $15 shipping, so that sounds like a last resort. Anyone else have suggestions?
-thomas