--- In
Mellotronists@yahoogroups.com, john barrick <astroboy@...>
wrote:
>
> Well, I'm onto the spillbox with 1407. Along with fabricating new
> brackets for the bottom, I'm wondering if there's a prescribed
method of
> cleaning the big felt pad at the front of the spillbox where the
tape
> enters? The piece on 1407 is pretty dirty, and I'm not sure what
the
> best method would be - maybe purchase a new piece? Is it safe to
assume
> that wiping down the box itself with a damp (water) rag is ok - it
looks
> to be finished in some kind of light varnish or shellac.
>
> On a different note, I've noticed after reassembling the keyboard
that I
> have a couple of notes that stick when depressed. The best
solution
> I've found so far is to switch the pinch roller assembly out with
other
> keys, so they attach differently to the frame - this has gotten
one key
> unstuck (they're both black keys) and I'm still switching out the
other
> hoping to find the right pinch roller assembly for it. I had the
keys
> off the frame for about a week - is it possible that some of them
might
> warp during that time?
>
> john
>
Re; Hi Again John
Last thing first, if you have a key that won't return after
depressing, the pinch roller is not a factor, it merely goes along
for the ride on what the key does. Since I assume you disassembled
the keys from the frame, it is most likely a misalignment. Since
this is your first time at this, the logical thing is to recheck
your work step by step methodically eliminating possibilities. One
of my keys had a 10 degree twist but still managed to return, so we
can assume it is a matter of readjustment here or a felt insert on
bottom of key had shifted. At any rate the first step would be to
remove the stop bar from top of key frame. Lift suspect keys up and
check felt insert on underside to see if it became unseated. Make
sure nyloc nut at rear of frame holding roller and tension assembly
is loose, I do not believe these are to be snugged down with nylock
as that is your return tension adjustment for key. Is the oval
guidepin symmetrically correct with adjoining pins? If this does
not fix problem, remove keyrack and seperate key from roller strip,
lay key on each side on known flat surface and chech for warpage. If
more than a trace of "twist" is found, key will need to be
straightened, if just a trace or none then proceed. Then Place key
in normal position and check for resistance between guide pin and
felt insert. You may, with key depressed on pin, gently rock it
clockwise and counter-clockwise if necessary to spread felt open ,
but be gentle here. Again recheck depressing key in normal
position. Reinstall key but do not tighten screw on bottom that
secures roller assy to key and try depressing key with it loose
going fore and aft and note any difference in return. With all
that, reassemble everything leaving screw on bottom of key loose and
retry depressing suspect keys, find spot with least resistance,
tighten and recheck. If you indeed have exessive "twist" or warpage,
key will need to be re straightened, another topic.
As for cleaning strip on spillbox, if the material looks brittle,
would probably be best to leave it be for now and think of replacing
it. If you think it will withstand cleaning, try a foam upholstery
cleaner as this will "lift" soil matter out and when good and dry
you can dab it with cloth to remove dirt. I cleaned the wooden box
with orange furniture cleaner and then used furniture polish with
several applications and buffed, looks like it was varnished
yesterday.
Also I will leave you my phone # in offline post, as some of this is
explained easier one on one. Hope that helps ... Doug