[sdiy] sn76477 external control

[Rude 66]

thanks! those articles included some good ideas.. it turned out to be as
easy as soldering pin 16 to an external jack input for the cv. it's now
happily chugging away arpeggios. also kinda found my gate mode again.. so
even no need for external machines. i am happy, though it has a range of
about 1/2 octave through external cv, and it's backwards too. maybe it's
compatible to the kawai 100f..:)
anyway, i can finally start with those sicker than sick basslines i've heard
this thing play in my mind..

r./



----- Original Message -----
From: "Ullrich Peter" <peter.ullrich at kapsch.net>
To: "Rude 66 " <r.lekx at chello.nl>
Cc: <synth-diy at dropmix.xs4all.nl>
Sent: Tuesday, May 28, 2002 8:52 PM
Subject: RE: [sdiy] sn76477 external control


Hallo!

>the only thing i haven't quite figured out is the external control. when
>i first got it, it reacted to my mono/poly's arpeggiator, doing gate and
>limited pitch. it has inputs for that, which don't seem to be working
>naymore.
>since this is basically someone else's project, it's kinda hard to
>figure out what does what. does anyone know how to add especially cv-in to
>the
master oscillator? to gate it i can always run it through another
>synth,but some kind of external pitch control would be nice.

Have a look at the articles with the SN76477 on my homepage
http://www.ullrich.at.tt !!!

Switch to English if you want / then Music / and then click on my old
SN76477
synth near the bottom of the page. There is also a project with a keyboard!

Ciao
Peter

http://www.ullrich.at.tt