this is a cross post from vintage synth - someone recommended i post the same question here so... here we go:
my cs-60 is in pretty good condition but there's an indentation in the ribbon controller - this means you cannot "press any position as a starting point" - the only starting point on the ribbon controller is where the indentation is - i noticed the lid for the cs-60 has a support that holds the lid away from the controls - the support rests right on top of the ribbon controller in the indented spot! is this a design flaw? did someone put this particular lid together wrong? should i only use the lid during transport? remove the support? does the cs-80 lid have this issue too?
also... how hard is it to fix the ribbon controller in this state?
also... how hard is it to fix the ribbon controller in this state?