Yamaha CS80

10,000 bulbs... how you gonna off-load them...!? Now, if they were 10,000 VCO chips.... well, a different kettle of silicone...;c)

Cheerz,
TOM



--- In yamahacs80@yahoogroups.com, "Mike" <mborish_2000@...> wrote:
>
> Ok, So I got the first models in and they are close but not quite the same, I think.  There is a voltage drop of about 100mv more than the originals and they are slightly  brighter and whiter - this is very subtle. They also run a tiny bit hotter.  It could be that the ones in my CS-80 are old and don't have the output that they had when they were new.  I have tested the new ones extensively and they seem OK.  The IG00157 doesn't get hot either.  
> 
> Does anybody know anything about the IG00157?  What are the specs?  If the specs confirm that these bulbs are OK, then we are good to go and I can order a couple thousand. 
> 
> Also, before I make a move, there is another bulb model that I want to check out first because it could be a better fit; it draws a third less current and has a third less lumens.  Unfortunately,  I might need to order 10,000 of them and wait 3 months.  Ha Ha 
> 
> Any comments or suggestions will be appreciated.
> 
> -Mike 
> 
> --- In yamahacs80@yahoogroups.com, "Mike" <mborish_2000@> wrote:
> >
> > I finally cross referenced the preset bulbs to the exact specifications of the originals - same shape, lumens, wire leads, filament type, etc.   I'm going to buy a bunch of them if the samples check out ok that I ordered.  Is anybody interested in preset bulbs?
> >
>