Yamaha CS80

No springs Kent, just make sure you pull it up level, that is at the same rate both ends. It is kinda heavy I suppose (because you're leaning over to do it) but I'm used to it. The cables (looms) are designed to 'give' as it rises so there shouldn't be a problem if you go slowly.




--- In yamahacs80@yahoogroups.com, omegacode80 <omegacode80@...> wrote:
>
> Thanks Tom!  Is it really heavy when you're pulling it up?  Is there a  
> spring mechanism that lifts it once you unscrew the bolts?  I haven't  
> studied the anatomy of the side rails too carefully yet.  Just opened  
> up the case and started looking around.
> 
> I'm sure I'm gonna have to carefully make sure no cables get caught up  
> on anything.
> 
> Cheers,
> 
> Kent
> 
> 
> On Apr 5, 2009, at 12:10 PM, Quazimodo wrote:
> 
> > Hi Kent,
> > Two bolts will need to be undone (one either side) and then the  
> > whole rack just slides up and locks by itself. To lower, you just  
> > raise it slightly (so it un-locks) and then gently lower it back down.
> >
> > Cheers
> > TOM
> >
> > --- In yamahacs80@yahoogroups.com, omegacode80 <omegacode80@>  
> > wrote:
> > >
> > > Hi Everyone,
> > >
> > > After mastering the M-board tuning procedure on my CS-50 I am now
> > > ready to tackle the tuning procedure for my CS-80.
> > >
> > > Can anyone provide pointers on how to safely raise the circuit board
> > > rack in to the "tuning" position? I don't see a procedure for doing
> > > this in the service manual.
> > >
> > > Cheers,
> > >
> > > Kent
> > > New York, NY
> > >
> >
> >
> > 
> 
> 
> 
> [Non-text portions of this message have been removed]
>