Yamaha CS80

You mean a BD234 or 2sd234 right?  Thanks for responding Kent.  I'm going to give it a shot.  On another note, do you sell extraction springs for the ribbon controller?

-Mike

--- In yamahacs80@yahoogroups.com, kent spong <kent_spong@...> wrote:
>
> 
> Hi 
>  
> 
> I would replace the tip31 and instead use a BD324
> 
>  
> 
> > ,
> 
>  
> 
> To: yamahacs80@yahoogroups.com
> > From: mborish_2000@...
> > Date: Thu, 26 Mar 2009 16:44:01 +0000
> > Subject: [yamahacs80] Help with 8.5v rail
> > 
> > A few months ago, I accidentally shorted the 8.5v rail to ground while calibrating VR723. (I know, I'm an idiot.) Common sense told me to take out TR709, check it and replace. I replaced TR709 with a TIP31C as well as IC722 and still have the same problem on the output: 3 volts and some change. I Removed the lead and get about 7.8 volts with the PSU unloaded and a little bit less with a 1M ohm load. The metal oxide resistor reads about 8/10 of an ohm in circuit.
> > 
> > I was wondering if anybody could post what some of the voltages are in their CS-80 PSU for me. It would be nice if I could have the voltages from TR711, TR710, D713 and IC722
> > 
> > 
> > 
> > ------------------------------------
> > 
> > Yahoo! Groups Links
> > 
> > 
> > 
> 
> 
> _________________________________________________________________
> View your Twitter and Flickr updates from one place – Learn more!
> http://clk.atdmt.com/UKM/go/137984870/direct/01/
> 
> [Non-text portions of this message have been removed]
>