Discussion about the Korg PolySix synthesizer

 From: Terje Winther <terje.winther@wintherstormer.no>
To: PolySix@yahoogroups.com 
Sent: Saturday, February 16, 2013 11:35 PM
Subject: [PolySix] Missing hardware - where to find?
 

  
I have a Polysix in for service that is missing a lot of hardware:
- the 4 bottom screws that hold the back end of the front panel are 
missing
- the 4 top screws (two on each side) that holds the front panel in 
place are missing
- a lot of the small black front panel screws that holds the panel 
PCBs in place are missing
- the inside screws (wood screw type) that holds the processor board 
in place are missing
- one of the screws for the pitchwheel/modwheel assembly (from the 
underside) is missing
- one of the rubber feet (including the screw) is missing

The whole thing is barely holding together.
Amazingly enough the look of this P6 is quite good, and all front 
panel elements (buttons, knobs, program caps etc.) are still there.
Technically it is in poor shape, and clearly someone has already tried 
to do "service" - unsuccessfully, and didn´t even bother to assemble 
the synth.

So: where do I start to look for hardware for the Polysix?

Terje Winther
terje.winther@wintherstormer.no
http://www.wintherstormer.no/


 

[Non-text portions of this message have been removed]