Discussion about the Korg PolySix synthesizer

Hi everyone!

I had a problem with my Polysix so I opend it and saw two cables that was just solderd to one side, the other side is just hanging.

I was wondering if anyone here at the list could help me to find out where the cables should be solderd in the other side.

I Have taken 2 photos of the boards, one is from KLM-369 whe a blue cable is solderd to D1 and it seems like it's following the other blue cables ( the one with the white connector)
http://www.flickr.com/photos/technogenic/6785932866/


The other cable is coming from R2 an R3 from board KLM-370 looks like it's  the ground.  
http://www.flickr.com/photos/technogenic/6932052229/

Thank you for your help in advance.

Regards
/D

Sent from my iPad

The blue wire to D1 is +5v to power the MG light, the LED that blinks to
show MG speed, and should be connected to the power supply board KLM-376
where it says +5. The fat black wire from R2/R3 is a ground wire that should
be connected to ground along the left side of the KLM-367 board.

 

Don Backshall.

 

  _____  

From: PolySix@yahoogroups.com [mailto:PolySix@yahoogroups.com] On Behalf Of
Darijo Berkes
Sent: Sunday, February 26, 2012 12:56 PM
To: PolySix@yahoogroups.com
Subject: [PolySix] help to find out where 2 cables are going?

 

  

Hi everyone!

I had a problem with my Polysix so I opend it and saw two cables that was
just solderd to one side, the other side is just hanging.

I was wondering if anyone here at the list could help me to find out where
the cables should be solderd in the other side.

I Have taken 2 photos of the boards, one is from KLM-369 whe a blue cable is
solderd to D1 and it seems like it's following the other blue cables ( the
one with the white connector)
http://www.flickr.com/photos/technogenic/6785932866/

The other cable is coming from R2 an R3 from board KLM-370 looks like it's
the ground. 
http://www.flickr.com/photos/technogenic/6932052229/

Thank you for your help in advance.

Regards
/D

Sent from my iPad





[Non-text portions of this message have been removed]