So I pulled the key assigner, the NEC8049C 217 out of my working Polysix and popped it into the one that wasn't working and it works, sooooo now I've got to source a NEC8049C
217. Anyone got any leads?
Thanks
Barry
From: PolySix@yahoogroups.com <PolySix@yahoogroups.com> on behalf of Florian Anwander fanwander@mnet-online.de [PolySix] <PolySix@yahoogroups.com>
Sent: Wednesday, April 24, 2019 9:34 AM
To: PolySix@yahoogroups.com
Subject: Re: [PolySix] Arpeggiator and Keybed not working
Sent: Wednesday, April 24, 2019 9:34 AM
To: PolySix@yahoogroups.com
Subject: Re: [PolySix] Arpeggiator and Keybed not working
Are you sure that you connected the cable from the keyboard to the
KLM366 in the right orientation?
Am 24.04.2019 um 14:39 schrieb Barry London eveready9v@hotmail.com
[PolySix]:
>--
> Hi there,
>
> So I’m just diving into this Polysix repair, the 367 was shot so I
> ordered a https://synthronics.de/klm-367a-replacement/ and swapped out
> the 8048C-345 and hooked it up but no activity from the keyboard or
> the arpeggiator. When I click through the memory banks I’m definitely
> hearing changes in fx or in LFO rates, and the filter is working, so
> I’m thinking it’s something on the 366 board, but figured I’d ask here
> if anyone had any recommendations on what to zone into first. I also
> have a working polysix at my home so was thinking about swapping out
> the 8048C-217 and see if it’s just a bad chip. Anyway any help is
> always appreciated.
> Thanks so much,
> Barry
http://www.florian-anwander.de