Discussion about the Korg PolySix synthesizer

Is there any advantage to attempting to fix the traces over using a jumper?

> On Jun 6, 2018, at 08:34, Bob Grieb bobgrieb@yahoo.com [PolySix] <PolySix@yahoogroups.com> wrote:
> 
> Don't use only solder to bridge the traces across the crack.
> Scrape off the solder mask on either side for maybe 1/4" or more
> and lay a piece of resistor lead or something similar across the 
> crack then solder to the trace on both sides. In really severe cases,
> you could glue something flat like a piece of some old pc board
> to this one to span the crack in-between where the traces are to make
> it stronger. In most cases just fixing the traces is enough.
>