Since the Mod switch and the Waveform switch depend on the P12, P13 signals
from KLM-367 to the panel boards, maybe this is a connection problem on CN06
(the blue wires) and not a problem on the clone board.
Don B.
Sent: Thursday, March 1, 2018 5:22 AM
Subject: Re: [PolySix] P6 MG Oddity
Ok thanks, I'll be aware of that when following the service manual.
Just to note what you mentioned about PWM, I have indeed now noticed that
MG behaves differently if I select Waveform PWM, on this wave I do get some MG
VCO Modulation but still with some VCF.
With Saw or PW Waveform there is no MG VCO Modulation (as my original post)