Indeed, the one I was working on is IC22! NOT 18, sorry!
On Friday, September 4, 2015 3:02 PM, "backshall1@bellsouth.net [PolySix]" <PolySix@yahoogroups.com> wrote:
It looks like IC18 on the 366B is a TL072 (8-pin chip) in the tuning
circuit. He was definitely talking about the 367 board, where IC18 is the 14051
demultiplexer for the filter and envelope control voltages. Pin 11 is one of the
address lines that control it. Neither of them seem to be the kind of thing that
would cause the type of noise you are hearing. Can you upload a picture of the
top of the board, showing the chip you are working on?
Don B.
Sent: Friday, September 4, 2015 9:32 AM
Subject: Re: [PolySix] Re: Noisy Polysix
Thanks, well IC18 on the 367 board is fine
on pin 11 and the others, however IC18 on 366 is not fine. In fact a bunch of
previous re-tracing has been done on it and currently pin 11 is not showing
continuity. I dunno if you meant me to check IC18 on the 366 board?
On Friday, September 4, 2015 2:19 PM,
"backshall1@bellsouth.net [PolySix]" <PolySix@yahoogroups.com>
wrote:
Sorry, the KLM-367 (the programmer board) is commonly called the “digital”
board since it has the A/D circuit, memory and D/A chip and the KLM-366 is the
“analog” board, since it has the oscillators and filters. They both have CPU
chips and quite a bit of digital circuits, so using those names can be
confusing. Sometimes the 366 is called the voice board, but I think the official
name is the key assigner board.
Don B.
Sent: Friday, September 4, 2015 8:54 AM
Subject: Re: [PolySix] Re: Noisy Polysix
366B I guess...