Hello
did you start the demo from the "manual" setting or from a progam setting?
It is important, that you do it in manual mode. Otherwise it is not
really possible to deduce the relation between the misbehaviour and and
the parameter settings.
For example the "distortion" coming in at 1:25 might be a fast LFO
modulation.
It would be also helpful if one could see the whole synth all the time.
Use a camera stand and place it above the synth
Florian
Am 28.05.2015 um 17:07 schrieb Johan De Vroede johandevroede@yahoo.com
[PolySix]:
did you start the demo from the "manual" setting or from a progam setting?
It is important, that you do it in manual mode. Otherwise it is not
really possible to deduce the relation between the misbehaviour and and
the parameter settings.
For example the "distortion" coming in at 1:25 might be a fast LFO
modulation.
It would be also helpful if one could see the whole synth all the time.
Use a camera stand and place it above the synth
Florian
Am 28.05.2015 um 17:07 schrieb Johan De Vroede johandevroede@yahoo.com
[PolySix]:
>
> You can find a film that shows the defect that I have on my Polysix.
> You will see that it is the VCF that seem to control the EG. Also the
> VCF doesn't work as it should.... I hope someone can figure out what
> could be the cause and what could fix it.
> VCF defect in Polysix
> <https://vimeo.com/129104997?utm_source=email&utm_medium=clip-transcode_complete-finished-20120100&utm_campaign=7701&email_id=Y2xpcF90cmFuc2NvZGVkfDA0OTQ0MGQ2YjE0MjkzZjdlMWM5YzQwZjNjNTIzZjdmNjZ8NDA1NzQ0MTh8MTQzMjgyNDIxOXw3NzAx>