Does the op amp on the klm367 that buffers the cutoff voltage from the S&H change when you change the front panel control?
From:
f115@rocketmail.com [PolySix] <PolySix@yahoogroups.com>;
To: <PolySix@yahoogroups.com>;
Subject: Re: [PolySix] Re: Clone - MG always on by default
Sent: Fri, Oct 24, 2014 4:17:12 PM
To: <PolySix@yahoogroups.com>;
Subject: Re: [PolySix] Re: Clone - MG always on by default
Sent: Fri, Oct 24, 2014 4:17:12 PM
Well I'm afraid I haven't quite got the build right after all. I could really use the help.
- MG is on for sure
- Cutoff not working
- I can't write to patch either. I tried saving patch A1 as a clean non modulated patch and it didn't pick it up.
I'm baffled. These seem to be somewhat unrelated! Cutoff certainly connects with the MG I/O on CN05 but then tape enable is on CN08.
Attachments
- No local attachments were found for this message.