Did you fix the two pcb mistakes described here: https://sites.google.com/site/jedjorgensen/klm367a/images/pcb-bugs-errors
The second one is the mg delay...
Hey everyone!
Well at long last I revisited my KLM clone build and finally got it up and running... almost!
Calibration went smoothly but I have one last piece to tackle. The MG seems to be on in some way no matter what patch is chosen. I uploaded the Factory A banks so that's the point of reference. Patch A1 should just be a clean brass with a delayed MG. I even swapped out T1/Q1 with an original from my old board but that didn't seem to make any difference.
I scoured the message archive but didn't find anything. I thought that was a fairly common issue for all Polysixes. Perhaps I was mistaken.
Thanks!