Discussion about the Korg PolySix synthesizer

Some pedals makers.. (bespeco, roland) offer pedals that simply slide the sides together.  I know that the bespeco pedals actually offer:
                 a) sustain pedal with switch to adjust polarity (+ or -)
                 b) latching pedals (on/off)
        These Bespeco pedals are inexpensive and fairly well built for the price ($18-24 canadian), and can slide together the same way the roland pedals do...
Thus you have a simple pedal board (well, physically that is).. still have the cables to each synth to deal with + the poly6 sustain issue.


Cheers.
Jay





----- Original Message ----- 
  From: Chromatest Pantsmaker 
  To: PolySix@yahoogroups.com 
  Sent: Thursday, September 11, 2003 2:36 PM
  Subject: Re: [PolySix] Any ideas?



  ----- Original Message -----
  From: greg montalbano <greg.montalbano@ucop.edu>


  > As far as a single switch to control multiple synths, that could be easily 
  > done by using a standard footswitch to control a circuit using a 4066 type 
  > CMOS electronic switch, which could send the on/off control signals to four 
  > destinations.  You could also work something similar with an off-the-shelf 
  > relay.  Depending on how elaborate you want to get, you could also add 
  > on-off toggles to the individual outputs to control the routing.


  I was thinking of the same thing.. toggle switches for individual synths and all, except I wasn't going to use any IC's.. just get 4 pedals and nail a board across the top of them all.  :)

        Yahoo! Groups Sponsor 
       
       

  To unsubscribe from this group, send an email to:
  PolySix-unsubscribe@yahoogroups.com

  PolySix "Digiest" Page: http://www.acc.umu.se/~amber/Poly6 

  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 


[Non-text portions of this message have been removed]