Discussion about the Korg PolySix synthesizer group photo

Yahoo Groups archive

Discussion about the Korg PolySix synthesizer

Index last updated: 2026-04-28 23:40 UTC

Message

Bank A and Program 1 LEDs Always On.

2014-01-02 by <josh.nursing@gmail.com>

Caught a disconnected trace from IC31 and pin 2 of the Resistor Array and successfully jumpered it, as well as fixed the broken trace on the MG control board as mentioned in another thread. I also found that a white wire was disconnected from the the cable between KLM-367 and that control board, so repaired that as well, and in addition, had to swap power distribution board.

Now, what I can see is that both Bank A and Program Led 1 are always on. If I press Bank B and Program 2, then 4 LEDs remain on, as Bank A and LED 1 are still on...


Attachments

  • No local attachments were found for this message.

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.