Discussion about the Korg PolySix synthesizer

Perhaps it's a good idea to check supply voltages.

  ----- Original Message ----- 
  From: tonezone020 
  To: PolySix@yahoogroups.com 
  Sent: Friday, August 31, 2012 7:38 PM
  Subject: [PolySix] Re: Voices not working


    
  Hi Peter.

  I took the "best" pair (SSM2044+SSM2056) and placed them in different slots - slots are fine.

  I then placed the 2 broken 2044s with the best 2056 - no sound with either.

  I then placed the 2 broken 2056s with the best 2044 - no sound again.

  Any ideas before I replace them ?

  Best,
  Tony

  --- In PolySix@yahoogroups.com, Peter M�rck <peterm@...> wrote:
  >
  > Hi,
  > 
  > Are you sure both the 2044 and 2056 are dead for both of the dead voices?
  > I mean, have you swapped only one with a working voice and verified that the broken voice is still not fixed, PLUS that the previously working voice stops working at the same time?
  > Just want to make sure that you don't only test the broken voices and swap chips until it works and then assume all the swapped chipes were toast.
  > 
  > BR,
  > Peter
  > 
  > 
  > ----- Original Message ----- 
  > From: tonezone020 
  > To: PolySix@yahoogroups.com 
  > Sent: Friday, August 31, 2012 6:51 PM
  > Subject: [PolySix] Re: Voices not working
  > 
  > 
  > 
  > 
  > 
  > Hi,
  > 
  > I swapped both the SSM2044s and 2056s around for the dead voices and found that all 4 aren't working. 
  > 
  > Following on, the remaining SSM2044s have differing volume levels specific to the chip - not slot. 
  > 
  > I've reposition the ICs so I have voices 1-4 working and 5/6 not.
  > 
  > Will calibration sort out the sound levels and sonic inconsistencies for the working voices ?
  > 
  > Regards
  > Tony
  > 
  > --- In PolySix@yahoogroups.com, Bandit <tonymonta2002@> wrote:
  > >
  > > SSM 2044 ?� 
  > > 
  > > 
  > > ________________________________
  > > From: tonezone020 <swamp.gigs@>
  > > To: PolySix@yahoogroups.com 
  > > Sent: Friday, August 31, 2012 2:06 AM
  > > Subject: [PolySix] Voices not working
  > > 
  > > 
  > > � 
  > > Hi All,
  > > 
  > > Got a Polysix I've been working on and voices 1 and 3 are not sounding.
  > > 
  > > The leds show they're being triggered.
  > > 
  > > Any suggestions would be greatly appreciated.
  > > 
  > > Thanks in advance,
  > > 
  > > Tony
  > > 
  > > 
  > > 
  > > 
  > > [Non-text portions of this message have been removed]
  > >
  > 
  > 
  > 
  > 
  > 
  > [Non-text portions of this message have been removed]
  >



  

[Non-text portions of this message have been removed]