Discussion about the Korg PolySix synthesizer

Hi Peter.

I took the "best" pair (SSM2044+SSM2056) and placed them in different slots - slots are fine.

I then placed the 2 broken 2044s with the best 2056 - no sound with either.

I then placed the 2 broken 2056s with the best 2044 - no sound again.

Any ideas before I replace them ?

Best,
Tony

--- In PolySix@yahoogroups.com, Peter M�rck <peterm@...> wrote:
>
> Hi,
> 
> Are you sure both the 2044 and 2056 are dead for both of the dead voices?
> I mean, have you swapped only one with a working voice and verified that the broken voice is still not fixed, PLUS that the previously working voice stops working at the same time?
> Just want to make sure that you don't only test the broken voices and swap chips until it works and then assume all the swapped chipes were toast.
> 
> BR,
> Peter
> 
> 
>   ----- Original Message ----- 
>   From: tonezone020 
>   To: PolySix@yahoogroups.com 
>   Sent: Friday, August 31, 2012 6:51 PM
>   Subject: [PolySix] Re: Voices not working
> 
> 
>     
> 
> 
>   Hi,
> 
>   I swapped both the SSM2044s and 2056s around for the dead voices and found that all 4 aren't working. 
> 
>   Following on, the remaining SSM2044s have differing volume levels specific to the chip - not slot. 
> 
>   I've reposition the ICs so I have voices 1-4 working and 5/6 not.
> 
>   Will calibration sort out the sound levels and sonic inconsistencies for the working voices ?
> 
>   Regards
>   Tony
> 
>   --- In PolySix@yahoogroups.com, Bandit <tonymonta2002@> wrote:
>   >
>   > SSM 2044 ?� 
>   > 
>   > 
>   > ________________________________
>   > From: tonezone020 <swamp.gigs@>
>   > To: PolySix@yahoogroups.com 
>   > Sent: Friday, August 31, 2012 2:06 AM
>   > Subject: [PolySix] Voices not working
>   > 
>   > 
>   > �  
>   > Hi All,
>   > 
>   > Got a Polysix I've been working on and voices 1 and 3 are not sounding.
>   > 
>   > The leds show they're being triggered.
>   > 
>   > Any suggestions would be greatly appreciated.
>   > 
>   > Thanks in advance,
>   > 
>   > Tony
>   > 
>   > 
>   > 
>   > 
>   > [Non-text portions of this message have been removed]
>   >
> 
> 
> 
>   
> 
> [Non-text portions of this message have been removed]
>