Discussion about the Korg PolySix synthesizer

It works! It Works!! Thanks alot for everyone's suggestions! (turned out I had missed a solder trace). 
On to repair the next polysix - i'll be back;)

Sendt fra min iPhone

Den 10/05/2012 kl. 16.13 skrev "backshall1" <backshall1@bellsouth.net>:

> Also, the octave and waveform switches and the PW/PWM level are all sent
> through IC28 (14042) so check down around there for damage. This chip might
> need to be replaced.
> 
> Don B.
> 
> _____ 
> 
> From: PolySix@yahoogroups.com [mailto:PolySix@yahoogroups.com] On Behalf Of
> Malte Rogacki
> Sent: Thursday, May 10, 2012 2:31 AM
> To: PolySix@yahoogroups.com
> Subject: Re: [PolySix] Yet another battery leak victim..
> 
> Check the traces originating from CN06 on the KLM367 board.
> 
> BTW, the PW pot is probably just fine. If the waveform is set to PW (which
> it might well be since the switch doesn't work) the sound will stop at
> about 8 or so because at this point the pulse is getting too narrow.
> 
> Check also if the MOD switch for the LFO works.
> 
> [Non-text portions of this message have been removed]
> 
> 


[Non-text portions of this message have been removed]