Discussion about the Korg PolySix synthesizer

Hi Andy
I'm working on the original KLM367 board.

Cheers
Aniello

--- In PolySix@yahoogroups.com, Andrew Jury <andy@...> wrote:
>
> Are you working on an original KLM-367 or trying to calibrate the clone
> board?
> 
> Cheers,
> Andy
> 
> 
> On 05/07/2010 22:26, "aniello.iaccarino" <ani.bliss@...> wrote:
> 
> >  
> >  
> >  
> >    
> > 
> > Hi Friends
> > I recently did the adjustment procedure and I found two problems.
> > 
> > The first is: not all the leds BANK A-D, PROGRAMS 1-8, MANUAL and TAPE
> > ENABLE lights up when i turn VR1 from left to right, but every time I
> > pass a certain point of VR1 leds light up in different combinations.
> > [[-(]
> > 
> > I have to say that I can proceed to the calibration procedure anyway.
> > But I don't know If the result of the calibration procedure  could be
> > better if all leds light up instead some of them.
> > 
> > The second i found is that when I regulate MG speed I can't obtain a
> > cycle of 10-40 sec, but just 4 sec,  a very short cycle.  [[-(]
> > For this problem have I to check IC21 and C19?
> > 
> > Any suggestion?  [:D]
> > 
> > Thanks
> > 
> > Aniello
> > 
> > [Non-text portions of this message have been removed]
> > 
> >  
> >    
> > 
> > 
> 
> 
> 
> [Non-text portions of this message have been removed]
>