Discussion about the Korg PolySix synthesizer

Hi Andy,

ok so I tested the MG section. It works when put to VCF and VCO, but when it's on VCO it has no effect whatsoever.


Milan

--- In PolySix@yahoogroups.com, "Andrew Jury" <andy@...> wrote:
>
> Hi Milan,
> 
>  
> 
> Can you tell us if the MG section of your Polysix is in full working order?
> Particularly the modulation routing switch (VCA, VCF, VCO)? This may have a
> bearing on the problem if it is not.
> 
>  
> 
> Thanks,
> 
> Andy
> 
>  
> 
> From: PolySix@yahoogroups.com [mailto:PolySix@yahoogroups.com] On Behalf Of
> Mekonin
> Sent: 29 November 2009 09:48
> To: PolySix@yahoogroups.com
> Subject: [PolySix] Master tune + Mod wheels not working
> 
>  
> 
>   
> 
> Hello fellow Polysix lovers,
> 
> I am writing this in need of your help once again.
> 
> Few weeks ago my P6 started acting funny, it was detuned down for a whole
> octave and a half, and I noticed that master tune knob and mod wheels have
> no effect on the sound. I opened it up, saw if there are any loose cables,
> put it in test mode and back again, and when I returned it to "Normal", it
> was working as it should. But next time I powered it on (or the second time
> I can't remember), after some playing I noticed that the pitch was drifting.
> I tried the tune knob and mod wheels and realised that they are not working
> like that time before. This time, fiddling inside the P6 did not help.
> If you have any suggestions what might be the problem, please write.
> 
> Thank you all in advance,
> Milan
> 
> 
> 
> 
> 
> [Non-text portions of this message have been removed]
>