Discussion about the Korg PolySix synthesizer

YES, i scraped out the old traces (about 5),  even under the IC31, then replaced the Ic31.... But now that more of the  LED s stay on, im more confidant that the IC31 controls selecting the patches, but no one seems to confirm this . I wonder if i need to get another  IC31...do it again  with less heat applied to the IC when soldering....any other suggestions?


----- Original Message ----
From: Chromatest J. Pantsmaker <chromatest@azburners.org>
To: PolySix@yahoogroups.com
Sent: Wednesday, November 14, 2007 4:01:37 AM
Subject: Re: [PolySix] botched trace repair?

Did you totally remove the "bad" traces, or did you just jump them
with wire? The "bad" traces could still be shorting each other...

On 11/13/07, spistrich <wasteking@verizon. net> wrote:
> well i tried to replace IC 31 and a couple questionably corroded traces
> by jumping wires point to point. This was to to solve my polysixes
> problem of multiple patch keys LED's on all the time (such as D or #6
> or the "write ' key )...well, instead of only 2 being on all the time ,
> I now have 4 . Could i have overheated the IC 31?, the continuities all
> seem fine, the problem is some dont switch OFF.. could this be
> controlled by IC 31? I did possibly heat it too much? there are no 'bad
> traces'. left.
>
>
>
> PolySix "Digiest" Page: http://www.acc. umu.se/~amber/ Poly6
> Yahoo! Groups Links
>
>
>
>

-- 
.sig
-Chromatest J. Pantsmaker
http://www.chromate st.net



[Non-text portions of this message have been removed]