Hm I cleaned up all the trimpots.... I rather would like to know which IC could be wrong thanks a lot for reply.... Gregor > Are you refering to the trimpot on the computer board ? > > I don't know very much about it but on my Trident it did the same > when I set it to a cetrain position. This is how it was when I first > got it - powered it up and all banks/presets lite up. By ritating the > trimmer a bit it booted up correctly finally (bank 1 / preset 1) > > > --- In PolySix@yahoogroups.com, "u3dreal" <u3dreal@y...> wrote: > > > > Hello all; > > > > I bought a polysix in rather bad condition... > > > > I did the batteryreplacements and checked to circuits...they seem to > > be OK for both sides of teh PCB > > ...many things were still wrong then I replaced the IC31...and the > octave > > knob and the sub osc were working again. > > > > The Controls are better now but still don't work correctly.. > > > > the MG....Delay doesn't work at all and Level gets controlled by the > > VCO PW/PWM knob...? the EG doesn't seem to work either.. > > only the sustain can be controlled via the LFO resonance knob.. > > > > all the other things like the preset section / loading saving > progamms > > or even sending and receiving banks form external casset recorder > > works....!!!!! > > > > when i try to do the testing procedure with the 56k resistor...the > > following happens.....when i turn the trim clockwise there is a > point > > where is jumps from bankA prog1 to all eight proglights.....this > doesn't > > happen > > for me the two first ( prog 1+2) don' light...sometimes > > its only the first one which doesn't light... > > when i remove the resistor it switches back to prog1 bankA > > > > I have no idea what could be wrong...could it be IC30 or even the > > processor ?? Did you have something simlar ? > > > > How much would a new proc cost? > > > > I really would aprichiate it a lot if you could give me some > advice... > > > > > > thanks in advance > > > > Gregor > > > > > > > > > > PolySix "Digiest" Page: http://www.acc.umu.se/~amber/Poly6 > Yahoo! Groups Links > > > > > > ___________________________________________________________ Telefonate ohne weitere Kosten vom PC zum PC: http://messenger.yahoo.de
Message
Re: [PolySix] Re: Polysix wiered behaviour
2005-12-11 by u3dreal@yahoo.de
Attachments
- No local attachments were found for this message.