Lpc2000

At 09:06 PM 11/25/03 +0000, you wrote:
>I have been using the Nohau debugger for my project. All the code does
>is toggle a port. The code works fine while in debug mode, but when I
>pull the DBGSEL line low, and reset the part there is no code
>execution.
>
>When I read the flash, it verifies with the code, and if I remove the
>pullup and debug dongle while the debugger is "running", the code
>continues to execute. However as soon as I reset the part, I loose
>code execution.
>
>Anyone seen this problem?
A couple of sanity checks
         1 - You have checked that DBGSEL is indeed low?
         2 - Have you checked that P0.14 is high?  If not you may be in 
bootstrap mode.

Robert

" 'Freedom' has no meaning of itself.  There are always restrictions,
be they legal, genetic, or physical.  If you don't believe me, try to
chew a radio signal. "

                         Kelvin Throop, III