Lpc2000

Anders,

You had any luck yet?

Cheers,

Nick

--- In lpc2000@yahoogroups.com, "kjellberg_anders" <akj@...> wrote:
>
> 
> Nick,
> 
> Thanks for letting me know about your LPC 2106 problems. Since I'm 
> working from home today I do not have any other cables but I'll get 
> back to you as soon as I have tried a different one. As I wrote 
> earlier, I have tested different baudrates and made sure that the 
> comport was correctly setup. I'll check that with a scope tomorrow. 
> 
> Best regards 
> /Anders
> 
> 
> -- In lpc2000@yahoogroups.com, "nma550n" <nma550n@> wrote:
> >
> > Anders,
> > 
> > I am also having problems with the Philips LPC2000 flash utility 
> > (olimex LPC2106), and was just about to post a message on this 
> board 
> > to see if the problem lies with my development board.
> > I am just trying to upload the simple blink LED hex file to 
flash, 
> > and it just comes up with cannot communicate. I too have tried 
> many 
> > different com ports, jumper settings and different reset 
> conditions, 
> > to no avail. This is the first time I have tried to use this 
> board, 
> > so i have no idea if the thing works.
> > 
> > I am almost certain the problem does not lie with the Philips 
> LPC2000 
> > flash utility as I have scoped out the Rx signal (3.3v low, 0v 
> high) 
> > on the board and found it to receive data. 
> > However, my Tx pin on the chip is always at ground and does 
> nothing.
> > 
> > Does anyone know if Tx should be held at 0v???
> > 
> > Not sure if this will help you Anders, but just to let you know 
> your 
> > not alone.
> > 
> > cheers,
> > 
> > Nick
> > 
> > > --- In lpc2000@yahoogroups.com, "Anders Kjellberg" <akj@> wrote:
> > > >
> > > > Hi,
> > > > I'm trying to establish connection with Philips Flash Utility 
> and 
> > > an Olimex 2106 mt board without success. TheBSL jumper is 
> shorted 
> > > and the frequency set at 14745kHz (14.7456MHz). Different 
> baudrates 
> > > have been tried without success. I am not sure about the 
DTR/RTS 
> > > settings however. Also I may be using the wrong RS232 cable. 
> Null 
> > > modem or not? I'll have to check that. I intend to use the 
> > > bootloader and ICCARM. Any ideas that may help?
> > > > 
> > > > Thanks in advance!
> > > > /Anders
> > > > 
> > > > [Non-text portions of this message have been removed]
> > > >
> > >
> >
>