MG speed pot?
2010-09-14 by x
Hallo. Is there chance to modificate MG (VCF) frequency (speed) to control it by a pot?I don't think by Hawk 800. Thanx
Thread
MG speed pot?
Re: [korgpolyex] MG speed pot?
2010-09-14 by Michael Hawkins
VCF/DCO MG speed is determined by the LFO (or in the HAWK-800 - LFO1 or LFO2). Neither of which can be controlled by a POT because the speed is determined by the software. The only way to get control of LFO speed is with the HAWK-800 upgrade which then allows using a MIDI CC to control all four LFO's. Mike ________________________________
Show quoted textHide quoted text
From: x <pantvrdej@yahoo.com> To: korgpolyex@yahoogroups.com Sent: Tue, September 14, 2010 2:58:39 PM Subject: [korgpolyex] MG speed pot? Hallo. Is there chance to modificate MG (VCF) frequency (speed) to control it by a pot?I don't think by Hawk 800. Thanx
Re: MG speed pot?
2010-09-15 by x
So, is there chance to use another lfo instead of original to control VCF speed manually? Thank you --- In korgpolyex@yahoogroups.com, Michael Hawkins <korgpolyex800@...> wrote:
Show quoted textHide quoted text
> > VCF/DCO MG speed is determined by the LFO (or in the HAWK-800 - LFO1 or LFO2). > > Neither of which can be controlled by a POT because the speed is determined by > the software. > > The only way to get control of LFO speed is with the HAWK-800 upgrade which then > allows using a MIDI CC to control all four LFO's. > > Mike > > > > > ________________________________ > From: x <pantvrdej@...> > To: korgpolyex@yahoogroups.com > Sent: Tue, September 14, 2010 2:58:39 PM > Subject: [korgpolyex] MG speed pot? > > > Hallo. > Is there chance to modificate MG (VCF) frequency (speed) to control it by a > pot?I don't think by Hawk 800. > Thanx >
Re: [korgpolyex] Re: MG speed pot?
2010-09-15 by Michael Hawkins
Yes, check out pin 9 of IC1 (NJM2069). That is the linear VCF cutoff control point. Mike