Hi Christian,
I added some comments for the pics in the modification album.
And there's a small sketch of the wiring for the pots.
It may look confusing, but it's simple, and it has the opportunity to
switch between factory and perform mode (this is when the knobs are
working.)
The hardware working (drilling, soldering) isn't too hard, but you
have to be careful, of course. The pots are not going out very
easily, just destroy them before you damage the PCB!
Greetings,
Olaf
I added some comments for the pics in the modification album.
And there's a small sketch of the wiring for the pots.
It may look confusing, but it's simple, and it has the opportunity to
switch between factory and perform mode (this is when the knobs are
working.)
The hardware working (drilling, soldering) isn't too hard, but you
have to be careful, of course. The pots are not going out very
easily, just destroy them before you damage the PCB!
Greetings,
Olaf