Korg Poly800/EX800 Users

you must install the jumpers (if it's a single sided version). So you
need to life those sockets out of the board. Use a very thin tweezers
or thin flat screw driver to work them out slowly.
If the board is double sided, it's rather obvious that jumpers are not
needed.
/MikeOn Sun, 2019-09-01 at 17:40 +0000, domgoold@... [korgpolyex]
wrote:
> Hi Mike, 
> ok: i remember what puzzled me when i first looked at the kit and the
> instructions:
> 
> i'm at the stage where the jumpers are to be installed on the Hawk
> board.
> the board came with 2 DILs in the first leftmost positions. 
> they seem pretty firmly in place - are they factory soldered, or to
> be removed? 
> i can't get at the jumper positions underneath them-unless i solder
> to underside.
> 
> also, it does not look like the drawing in the instructions.it is
> v1.3
> 
> in the drawing, it shows the circled small jumpers, and one long
> jumper coming 
> through DIL #2 up to the top of the board. 
> 
> on mine, this one is shorter and ends roughly under the DIL
> position. 
> (according to the markers on the pcb)
> 
> some other differences as well.
> 
> ah? or are these tracks, and i don't have to do the jumpers?
> (do i remember something about this? ...)
>