well, if you check out the MIDI implementation chart of the software version that I have not yet release - yes, you can control any running parameter using SYSEX.
Patch
parameter change
F0
42 21 0F xx yy F7 -
Change the current operating patch parameter where xx is the
parameter number (P1 11-88 corresponds to values 0-63 and P2
11-88 corresponds to values 64-127) and yy is the parameter data
value. Data values are scaled or absolute dependent upon global
parameter 47 (where 0 is scaled and 1 is absolute).
I just haven't had time to finish the one feature I really wanted to get into the next release which is dramatically improved portamento.
/Mike
From: "domgoold@... [korgpolyex]" <korgpolyex@yahoogroups.com>
To: korgpolyex@yahoogroups.com
Sent: Friday, December 11, 2015 6:46 AM
Subject: Re: [korgpolyex] Controller setup: Is there an easy way?
To: korgpolyex@yahoogroups.com
Sent: Friday, December 11, 2015 6:46 AM
Subject: Re: [korgpolyex] Controller setup: Is there an easy way?
Hi Mike,
do you mean by this that these 'NRPN' params can be controlled by Sysex as well?
i have some confusion with NRPNs, how to use them. - but manufs do seem to like them ! -
could you please describe step by step how you use NRPNs in an 'easy' way?
i'm thinking, terribly complicated, calling NRPN, and then sending data#6 - and this, as far
as i understand, means that NRPN will be assigned to MIDI CC#6 until you specify another
NRPN, or send a (?end of NRPN?) message.
the Novation Remote has a NRPN mode - i have a feeling it may deal with everything under the
bonnet, to make it usable, but i haven't checked.
>because, basically, what we want, is just to grab a control and tweak it, rather than having
to set up a complicated series of messages in a list editor, right..?
>wondering, bcause i'm getting the hang of the Remote now, and it's Remote Editor.
do you mean by this that these 'NRPN' params can be controlled by Sysex as well?
i have some confusion with NRPNs, how to use them. - but manufs do seem to like them ! -
could you please describe step by step how you use NRPNs in an 'easy' way?
i'm thinking, terribly complicated, calling NRPN, and then sending data#6 - and this, as far
as i understand, means that NRPN will be assigned to MIDI CC#6 until you specify another
NRPN, or send a (?end of NRPN?) message.
the Novation Remote has a NRPN mode - i have a feeling it may deal with everything under the
bonnet, to make it usable, but i haven't checked.
>because, basically, what we want, is just to grab a control and tweak it, rather than having
to set up a complicated series of messages in a list editor, right..?
>wondering, bcause i'm getting the hang of the Remote now, and it's Remote Editor.