Korg Poly800/EX800 Users

here's what Ctrlr is sending out-

[11:55:58:000959]: RAW:[f0 41 00 46 12 00 08 28 01 00 00 4f f7]
[11:56:04:000902]: RAW:[f0 41 00 46 12 00 08 28 01 02 00 4d f7]
[11:56:10:000078]: RAW:[f0 41 00 46 12 00 08 28 01 04 00 4b f7]
[11:56:13:000389]: RAW:[f0 41 00 46 12 00 08 28 01 06 00 49 f7]

thats B1-B4 in series.

Which byte am I after?
Is that even close to the instructions needed?



--- In korgpolyex@yahoogroups.com, Michael Hawkins <korgpolyex800@...> wrote:
>
> Check that global 16 matches your Bank Select MSB.
> 
> Global 16 defaults to 1. So you should send the bank select MSB as 1.
> 
> Or, if you're sending zero for the MSB then set global 16 to zero.
> 
> Mike
> 
> 
> 
> 
> 
> ________________________________
>  From: Michael Hawkins <korgpolyex800@...>
> To: "korgpolyex@yahoogroups.com" <korgpolyex@yahoogroups.com> 
> Sent: Saturday, October 20, 2012 9:52 PM
> Subject: Re: [korgpolyex] CC#32 Bank Select??
>  
> 
> Â  
> I shall have a look tomorrow and check to make sure this works.
> 
> Mike
> 
> 
> 
> ________________________________
>  From: bimmerfan222 <bperkins211@...>
> To: korgpolyex@yahoogroups.com 
> Sent: Saturday, October 20, 2012 1:45 PM
> Subject: [korgpolyex] CC#32 Bank Select??
>  
> 
> Â  
> I ran into a CC that has stumped me...
> 
> I setup a dropdown menu to pick Bank1, Bank2, Bank3, Bank4
> 
> I used CC#32 and use 0=B1  32=B2, 64=B3 & 96=B4
> 
> I get no reaction from the HAWK.. going manually into Global Mode will change Banks, but nada from the CC
> 
> any ideas?  I saw the Midi Imp. chart says "32 Bank Select (LSB)".  Then the description states, "uses two most significant bits so that you should send bank select data as 0-31=bank1,..."
> 
> Is this CC setup differently than the other standard CC's like VCF cutoff??
> 
> -Blaine
>