Q: I began to assume they were ref#'s meant for the firmware and not actual MIDI CC's.
A: I shall revise the document. It is confusing.
Q: I'm guessing it wouldnt be too terribly difficult to assign parameters to open CC#'s thru code alterations?
A: Adding some additional CC's for specific parameters is quite easy. But as I posted just now, it is impossible to map every parameter to a specific CC because there just are not enough available CC's. It's a MIDI limitation. And that is why RPN's and NRPN's were implemented in the MIDI specification.
A: Adding some additional CC's for specific parameters is quite easy. But as I posted just now, it is impossible to map every parameter to a specific CC because there just are not enough available CC's. It's a MIDI limitation. And that is why RPN's and NRPN's were implemented in the MIDI specification.
Q: NRPN is a great tool... it's just had to make me completely readjust my
gameplan for a custom controller project I've been slowly putting
together.
I'll get it working with NRPN, it just might not have all the features I thought I could design into it.
I'll get it working with NRPN, it just might not have all the features I thought I could design into it.
A: I don't see why using NRPN's would limit you.
Q: On another note, I finally ordered some encoders, D flipflops and quad bi lat switches. I should have a working data dial to put in a Poly here in about a week ;)
A: Cool, I'd like to see that.
Mike
From: bimmerfan222 <bperkins211@...>
To: korgpolyex@yahoogroups.com
Sent: Wednesday, September 5, 2012 9:34 AM
Subject: [korgpolyex] Re: CC issues...
To: korgpolyex@yahoogroups.com
Sent: Wednesday, September 5, 2012 9:34 AM
Subject: [korgpolyex] Re: CC issues...
> Those are the data values needed to select a particular parameter. Before you say it, you're right, it's confusing at best and downright silly at worst. I shall redo that sheet soon.\I began to assume they were ref#'s meant for the firmware and not actual MIDI CC's.
>
> Mike
I'm guessing it wouldnt be too terribly difficult to assign parameters to open CC#'s thru code alterations?
NRPN is a great tool... it's just had to make me completely readjust my gameplan for a custom controller project I've been slowly putting together.
I'll get it working with NRPN, it just might not have all the features I thought I could design into it.
On another note, I finally ordered some encoders, D flipflops and quad bi lat switches.
I should have a working data dial to put in a Poly here in about a week ;)
-Blaine