You can send a global sysex message to change globals. But the sysex for that is a global bulk type message. There are no CC's or Sysex to change individual global parameters (I have just added that as a feature request to sourceforge).
Yes, MIDI CC 21 allows control of the sequencer. Not sure why it wouldn't be working. I shall have to check that it is still functioning in the software, it should be.
Mike
From: dpaulo2 <dpaulo@...>
To: korgpolyex@yahoogroups.com
Sent: Saturday, August 11, 2012 12:10 PM
Subject: [korgpolyex] now it;'s a question about sysex!
To: korgpolyex@yahoogroups.com
Sent: Saturday, August 11, 2012 12:10 PM
Subject: [korgpolyex] now it;'s a question about sysex!
Mike, hello again,
my software editor is looking good, however I'd like to integrate controls for the sequencer also.
So far I've used the "Quick Parameter Change" method to get communication for everything else, but I see I need to access one or two Global Parameters and also MIDI control no. 21. Alas I've found no way to do this, I guess it's via a sysex message, but so far all sysex messages I've tried have not registered on the synth.
Hope you can help,
Dan
my software editor is looking good, however I'd like to integrate controls for the sequencer also.
So far I've used the "Quick Parameter Change" method to get communication for everything else, but I see I need to access one or two Global Parameters and also MIDI control no. 21. Alas I've found no way to do this, I guess it's via a sysex message, but so far all sysex messages I've tried have not registered on the synth.
Hope you can help,
Dan