Only if the pot value is too small, than the ground will leak and you will
loose signal power, if you are using a 50k or bigger it should be ok, I do
prefere B 50k linear pots instead of log audio taper, the response is
much smoother. Also I do put a general porpouse diode bettween the
cutoff pot's positive out (middle terminal) and the pcb to prevent short
circuit and signal loss. The diode could be an 1N4148, very easy to find.
Em 18/07/2011 21:37, 7yash < josh.nursing@... > escreveu:
loose signal power, if you are using a 50k or bigger it should be ok, I do
prefere B 50k linear pots instead of log audio taper, the response is
much smoother. Also I do put a general porpouse diode bettween the
cutoff pot's positive out (middle terminal) and the pcb to prevent short
circuit and signal loss. The diode could be an 1N4148, very easy to find.
Em 18/07/2011 21:37, 7yash < josh.nursing@... > escreveu:
Tried the Moog Slayer pot mod with pots I had in hand. If I use a smaller pot resistance value, it's normal that I get a low range, right?