Korg Poly800/EX800 Users

Hey Atom,

Thanks for your post. I think I found out what I needed by measusing
it with my electrical meter. I'm gonna post it here anyway for all who
are intereted.

The following pins are connected if program write switch is set to
enabled. (For orientation - the Out L and Out R head to the right side
up. I look at the program write switch from below.)

ooo++o
ooo++o

If the Program write switch is set to disabled the following pins are
connected:

oooo++
oooo++

My thoughts were that if I put another switch between the connected
pins I could remotely switch the program write switch on/off.Only my
mistake was that I soldered it this way:

oooooo
ooo++o
          ||      _/_
          ||    |___|
          ||___|||
          |____|

(I hope somebody can understand this-the box in the bottom is supposed
to be a 3pin on/off switch)

And that left two pins still connected to each other - so the
connection wasn't interupted. Now I'm going to try a 6 pin on/off
switch so that I can cut the connection completely. I think that
should do it.

Cheers :)
Flo