Synth-DIY Yahoo! Groups Archives

Re: [emulatorII-list] Is it possible to swap out Logic boards between Rev.0 and Rev.1 EII's?

2012-01-06 by Ryan Supak

I don't know the answer to this question but I suspect it's OK.

The Service Manual has a detailed description of revision differences/kludges as well. So you might be able to ascertain it from there. If you do try it and succeed I'd like to know.

rs
On Thu, Jan 5, 2012 at 5:38 PM, trickstar303 <trickstar303@...> wrote:

Is it possible to freely swap out the logic boards between Rev.0 and Rev.1 EIIs or are there differences on the analog boards between the different revisions as well?

George

Re: Is it possible to swap out Logic boards between Rev.0 and Rev.1 EII's?

2012-01-10 by czh90

I swapped them freely on a couple of units I'm working on. The analog boards are the same. The only caveat I can think of is that the non-modified Rev.0 has an RS232 port, and they updated it on Rev 1 to RS422 for Sound Designer/Mac support.

--- In emulatorII-list@yahoogroups.com, Ryan Supak <ryansupak@...> wrote:
>
> I don't know the answer to this question but I suspect it's OK.
> 
> The Service Manual has a detailed description of revision
> differences/kludges as well. So you might be able to ascertain it from
> there. If you do try it and succeed I'd like to know.
> 
> rs
> On Thu, Jan 5, 2012 at 5:38 PM, trickstar303 <trickstar303@...> wrote:
> 
> > **
> >
> >
> > Is it possible to freely swap out the logic boards between Rev.0 and Rev.1
> > EIIs or are there differences on the analog boards between the different
> > revisions as well?
> >
> > George
> >
> >  
> >
>