it does sound like a termination problem. �old computer systems were so sensitive to that stuff.
�
what's the HxC?
i'm not super savy with Eii innards..
do you have the service manual?
http://www.emulatorarchive.com/Manuals/ManualsE123/manualse123.html
there's an upgrade manual as well.
z
NEW ALLIANCE EAST!!!!
--------------------------------------
http://www.newallianceeast.com
http://www.newallianceaudio.com
http://www.myspace.com/newallianceaudio
http://www.c4rt.com
www.myspace.com/thecampaignforrealtime
--------------------------------------
http://www.newallianceeast.com
http://www.newallianceaudio.com
http://www.myspace.com/newallianceaudio
http://www.c4rt.com
www.myspace.com/thecampaignforrealtime
From: Jason
To: emulatorII-list@yahoogroups.com
Sent: Sunday, December 18, 2011 7:55 PM
Subject: [emulatorII-list] Problems after removing HD/New Eproms needed
To: emulatorII-list@yahoogroups.com
Sent: Sunday, December 18, 2011 7:55 PM
Subject: [emulatorII-list] Problems after removing HD/New Eproms needed
�
Hi all, I removed the existing HD from my machine. I removed all of the relevant hardware and put the Zilog chip in the socket where the daughterboard was. Now the floppy will not boot the machine.
It turns over three times, shows the SW version and then quits.
I am using a straight cable. Nothing else except the factory floppy drive is on it.
I am doing this downgrade to install the HxC in place of the HD.
I would like to have it and the floppy on the same buss.
I think I am going to need new scanner and main roms.
Does anyone have the capability to hook me up with them?
Even the type of eeproms they are, the firmware files and the type of programmer to be used would be fantastic to know as well.
I have tried messing around with the jumpers on the floppy but nothing has changed.
I have not been successful in getting the HxC on line either. So for now I just want to get the machine booting from floppy.
One thing at a time!
Thanks in advance, Jay
It turns over three times, shows the SW version and then quits.
I am using a straight cable. Nothing else except the factory floppy drive is on it.
I am doing this downgrade to install the HxC in place of the HD.
I would like to have it and the floppy on the same buss.
I think I am going to need new scanner and main roms.
Does anyone have the capability to hook me up with them?
Even the type of eeproms they are, the firmware files and the type of programmer to be used would be fantastic to know as well.
I have tried messing around with the jumpers on the floppy but nothing has changed.
I have not been successful in getting the HxC on line either. So for now I just want to get the machine booting from floppy.
One thing at a time!
Thanks in advance, Jay