emulatorII-list

Mmm... if both drives have the same problem, it means the problem is not caused by the drives (this would have been the easier type of problem :-)

Of course you can still try to re-connect the ribbon cable gong from the drives to the main board at the main board side, but since that side has a locked connector, there is only a small chance that there's a bad connection. Which means the problem is somewhere in the circuitry or is caused by a bad connection of an IC with its socket. Note that most ICs are sitting in a socket and that transportation can cause some of the ICs to come loose. You could have a visual double-check and maybe even slightly push down most ICs to make sure they are sitting fully in their socket (but be careful for static electricity !)

An old serial number is not necessarily a problem. But some of the old units are still lacking the RS422 port. Most have been upgraded afterwards, so maybe yours is fine in that area too (if so it means a small board is sitting on top of the digital board in the upper left corner, at the backside)

///E-Synthesist

--- In emulatorII-list@yahoogroups.com, Ed Baldi <edbaldi@...> wrote:
>
> Thanks for the response.
> Yes, same thing when I insert in other drive.
> Also if I power up with a disk inside the LED says that it's booting the OS but nothing ever happens.
> ebay seller insists all worked fine prior to shipping and has been very helpful in trouble shooting but I think I am at an impasse.
> 
> Other than being old, is the low serial # a really bad thing?
> 
> thx
> e
> 
> --- On Sat, 10/15/11, esynthesist <esynthesist@...> wrote:
> 
> From: esynthesist <esynthesist@...>
> Subject: [emulatorII-list] Re: Help for a newbie?
> To: emulatorII-list@yahoogroups.com
> Date: Saturday, October 15, 2011, 5:32 AM
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
>  
> 
> 
> 
>   
> 
> 
>     
>       
>       
>       That's a pretty low serial number you have :-)
> 
> Congratulations with the purchase.
> 
> 
> 
> What happens when you insert the disk in the other drive ?
> 
> The same thing ?
> 
> 
> 
> --- In emulatorII-list@yahoogroups.com, "edbaldi" <edbaldi@> wrote:
> 
> >
> 
> > Hello everyone and thank you in advance for any advise you can provide. I have trolled the various EII resources before posting but I am at a loss and looking for some guidance. 
> 
> > 
> 
> > EII (Model# 6028 Serial# 31)It was an ebay purchase and purportedly left the seller in full working condition. Here is what happens when I start up:
> 
> > 
> 
> > 1. I turn on the EII
> 
> > 2. It powers up and says insert diskette as the red light on top drive flashes
> 
> > 3. I insert disk into top drive and close the latch (i have tried about 100 different disks from the library that came with it)
> 
> > 4. the drive spins and the red lights flash, alternating between top and bottom drive
> 
> > 5. it continues in this state indefinitely while the LED reads "insert diskette" 
> 
> > 
> 
> > Thanks again for any info you can provide.
> 
> > 
> 
> > e
> 
> >
>