emulatorII-list

Assuming that your upper drive is Drive 1 and the lower one is Drive 2:
- Drive 1 = floppy drive --> use the "untwisted connector" of the twisted cable.
- Drive 2 = SD HxC --> use the "twisted connector" of the twisted cable.
- Set the J3 jumper of the HxC to "ID2/DriveA" (see manual of HxC)
- Don't change any jumper on the floppy drive, but make sure you use the floppy drive which was on Drive 1 originally. 

If the orginal Drive 1 floppy drive is broken, and you want to use the other one now as Drive 1, you'll have to change a jumper on the drive, unless you use the HxC as Drive 1 and the floppy drive as Drive 2. In the latter case the configuration will be:
- Drive 1 = SD HxC --> use the "twisted connector" of the twisted cable.
- Drive 2 = floppy drive --> use the "untwisted connector" of the twisted cable.
- Set the J3 jumper of the HxC to "ID3/DriveA" (see manual of HxC)
In this configuration it it still possible to copy banks from floppy to HxC, but not using the "Copy Disk" function. You'll have to load the bank and do a "Save Bank" to "Disk 1"

Note: I didn't test the above configurations, I just derive them from the documentation I have...  

///E-Synthesist 


--- In emulatorII-list@yahoogroups.com, "erwanquinquin" <erwanquinquin@...> wrote:
>
> 
> i have test the new firmware. Read and write work very well, so nice. But it is difficult to find the good IDE 34 pin cable. I would like to set the floppy drive as the upper drive ( to copy all my library on the hxc ) but I don't know how to set the jumber on the floppy drive cause of the "twisted" cable...
>