EmulatorII-list

Thanks for that mate.
Now, forgive my ignorance but, hot do you change the jumper settings?
And what are MM/SM jumpers?
AND what is the terminator resistor pack?
Is there any documentation around for this procedure?
Thanks again,
Martin



--- In emulatorII-list@yahoogroups.com, "esynthesist" <esynthesist@...> wrote:
>
> There are different jumper settings on the two drives.
> You should compare them and replace the ones from the working lower one 
> by the settings of the defective upper one before switching them.
> Also you'll have to remove the terminator resistor pack of the upper 
> drive drive and plug it into the lower drive before switching the 
> interface cables.
> Typical jumper differences are the DS (drive select), which should be 
> DS0 or DS1 for the upper drive and DS 1 or DS2 for the lower drive 
> (numbering starts either with 0 or 1, check the prints on the drive)
> Also there might be a difference with the MM/SM jumpers.
> 
> ///E-Synthesist
> 
> --- In emulatorII-list@yahoogroups.com, "Martin Dubka" <mdubka@> 
> wrote:
> >
> > Okay, my upper floppy drive is getting a bit temperamental so my plan 
> is to remove it and 
> > place the lower one in it's place, then fill the lower bay with a 
> route66 3.5" drive.
> > Would this be possible?  Are my two 5.25" drives identical?  And how 
> easy is it to carry out 
> > such an operation?
> > 
> > Cheers again,
> > Martin
> >
>