Disklavier

After moving my Mark 3 DC6A, I get the following Error message when I turn  
on the controller:
 
SENSOR LED ON ERROR
 
 
It completes the boot-up process like normal. 
 
Playback through both the CD player and the floppy drive is OK. 
 
I have not tried recording, yet.
 
Any ideas what the message means and what it affects?
 
Thanks, Group,  Glen

After moving my Mark 3 DC6A, I get the following Error message when I  turn 
on the controller:
 
SENSOR LED ON ERROR
 
 
It completes the boot-up process like normal. 
 
Playback through both the CD player and the floppy drive is  OK. 
 
I have not tried recording, yet.
 
Any ideas what the message means and what it affects?
 
Thanks, Group,  Glen

Try doing a recording. I don't believe you will be able to.

This message normally indicates that something in sensing system is disconnected or defective. Most likely disconnected.

Turn your piano off. Remove the fallboard of your piano and look to see if you see a disconnected cable. It may have become disconnected during the move.


Bill Brandom

 iPhone

On Oct 20, 2014, at 9:57 AM, GDPERRY@... [disklavier] <disklavier@yahoogroups.com> wrote:


 
 
 
 

After moving my Mark 3 DC6A, I get the following Error message when I turn on the controller:
 
SENSOR LED ON ERROR
 
It completes the boot-up process like normal.
 
Playback through both the CD player and the floppy drive is OK. 
 
I have not tried recording, yet.
 
Any ideas what the message means and what it affects?
 
Thanks, Group,  Glen

I had a similar problem with a previous Disklavier I owned which was a Mark 3. If you pull out the action there was a cable on the right hand side which was damaged and was causing intermittent problems. If you can't see red under the keys you can record or fully calibrate the piano. Yamaha sent me a complete new board and cable and I had no issues after that. 

Regards

Donal

> On 20 Oct 2014, at 18:11, Bill Brandom bill.brandom03@... [disklavier] <disklavier@yahoogroups.com> wrote:
> 
> Try doing a recording. I don't believe you will be able to.
> 
> This message normally indicates that something in sensing system is disconnected or defective. Most likely disconnected.
> 
> Turn your piano off. Remove the fallboard of your piano and look to see if you see a disconnected cable. It may have become disconnected during the move.
> 
> 
> Bill Brandom
> 
>  iPhone
> 
> On Oct 20, 2014, at 9:57 AM, GDPERRY@... [disklavier] <disklavier@yahoogroups.com> wrote:
> 
>  
> 
>  
>  
>  
>  
> 
> After moving my Mark 3 DC6A, I get the following Error message when I turn on the controller:
>  
> SENSOR LED ON ERROR
>  
> It completes the boot-up process like normal.
>  
> Playback through both the CD player and the floppy drive is OK. 
>  
> I have not tried recording, yet.
>  
> Any ideas what the message means and what it affects?
>  
> Thanks, Group,  Glen
>  
> 
> 
> 
> 
>  
>  
>  
> 
> 
>