Rhodes Chroma Polaris

The manual just talks about it either immediately kicking out with error honk, or it stepping through the sequence of patch lights to verify. I don't see anything about it just flashing 11 until the dump is finished then turning off and leaving the upper function light on.

Anybody seen this? Does 301039 have a different OS or something?

It's normal for the Polaris to only flash the #11 LED when you verify the program backup audio. Each flash represents that a program has been verified as readable, and can be properly loaded back into the Polaris. The Polaris won't flash through all the banks and program numbers until you actually load the programs. When you select "Load All Progs," it then overwrites each program in its memory with the programs in your backup audio.

~Ryan


Hotmail: Free, trusted and rich email service. Get it now.

Thanks so much Ryan. That wasn't really noted very well in the manual or anything that I could find so wasn't sure. I'll get this shipped then and make a note of that on the sounddoctorin.com/synthtec/synth.htm pages. Blessings, -Bob

--- In chromapolaris@yahoogroups.com, Ryan Freer <ryanfreer77@...> wrote:
>
>
> It's normal for the Polaris to only flash the #11 LED when you verify the program backup audio. Each flash represents that a program has been verified as readable, and can be properly loaded back into the Polaris. The Polaris won't flash through all the banks and program numbers until you actually load the programs. When you select "Load All Progs," it then overwrites each program in its memory with the programs in your backup audio.
>
>
>
> ~Ryan
>
>
>
> _________________________________________________________________
> Hotmail: Free, trusted and rich email service.
> http://clk.atdmt.com/GBL/go/201469228/direct/01/
>