Synth-DIY Yahoo! Groups Archives

Hard Reset

2016-10-10 by yarreau@...

Will I still be able to hear and program sounds after a hard reset (Lower/Diag/12)? or does that just remove the stored sounds?

Bill

Re: [chromapolaris] Hard Reset

2016-10-10 by David Gowin

If you do LF-Diags-12-Stop, it wipes out everything

Lower Function - D (Diagnostics) - 12, STOP / Erases all RAM and resets the microprocessor. Everything in RAM is wiped out; all adjustments, programs, and sequences. The Polaris must be reloaded and all factory adjustments must be performed following this particular function. Generally, this should be used whenever EPROM'S are changed to a different revision.

Below is the reference for the commands

http://www.rhodeschroma.com/?id=polarisservicediagnostics

----- Original Message -----
From: "yarreau@... [chromapolaris]" <chromapolaris@yahoogroups.com>
To: chromapolaris@yahoogroups.com
Date: Mon, 10 Oct 2016 15:11 -0400
Subject: [chromapolaris] Hard Reset

>
> Will I still be able to hear and program sounds after a hard reset (Lower/Diag/12)? or does that just remove the stored sounds?
>
> Bill
>
>

RE: [chromapolaris] Hard Reset

2016-10-10 by Paul D. DeRocco

> From: Bill <yarreau@...>
>
> Will I still be able to hear and program sounds after a hard
> reset (Lower/Diag/12)? or does that just remove the stored sounds?

It will erase everything, including the calibrations. You should hear scratch sounds, but you'll need to redo the calibrations before anything sounds right, and then reload your sounds via MIDI or the (cough) cassette.

--

Ciao, Paul D. DeRocco
Paul mailto:pderocco@...