Synth-DIY Yahoo! Groups Archives

VCS

2018-10-05 by Mike Burnham

Trying to compete a Voltage controlled slope

I have rev 1.0 boards

I can't get it to oscillate/cycle.

Is it important to change the 10nf caps on the trigger inputs to 1nf? I overlooked this when I was stuffing the boards

Thanks

Re: VCS

2018-10-05 by Ken Stone

Yes, without those caps changed, it will only oscillate at low frequencies. There is a resistor change there too. 150k to 100k from memory,

Show quoted textHide quoted text

On Fri, Oct 5, 2018 at 11:10 PM Mike Burnham mikejburnham@... [cgs_synth] <cgs_synth@yahoogroups.com> wrote:

Trying to compete a Voltage controlled slope

I have rev 1.0 boards

I can't get it to oscillate/cycle.

Is it important to change the 10nf caps on the trigger inputs to 1nf? I overlooked this when I was stuffing the boards

Thanks

--
Ken Stone otherunicorn@...

Cgs synth

VCS

VCS

Re: VCS

Move to quarantaine