I'll recheck Ken, thanks.
From: "Ken Stone otherunicorn@... [cgs_synth]" <cgs_synth@yahoogroups.com>
To: cgs_synth@yahoogroups.com
Sent: Monday, February 6, 2017 10:40 AM
Subject: Re: [cgs_synth] CGS 101 - Serge DCSM Ver 1.0
To: cgs_synth@yahoogroups.com
Sent: Monday, February 6, 2017 10:40 AM
Subject: Re: [cgs_synth] CGS 101 - Serge DCSM Ver 1.0
I presume it is the first version of the PCB. The resistor mods on the back of it are to deal with that problem. Make sure you soldered them to the right pins, and used the right values. Those cells have enormous gain without those resistors.
On Mon, Feb 6, 2017 at 10:16 AM, Stephen Richards okayjustalittle@... [cgs_synth] <cgs_synth@yahoogroups.com> wrote:
I have a finished version of CGS 101 in my custom panel with the Mods from the build page done and am experiencing very full on response from the Gain CV.Huge jumps in gain when CV is applied at the the Gain CV jack. Far too much for it to be workable.Is there any way to attenuate this incoming CV between the jack and RP/BP pads ? Would just a Resistor work here or is more needed ?
--