I decided to check up on myself and have a poke under the hood of my SWAMP panel.
The range pot wiring is vexing me...
Because i am using the CGS 31 V1.2 Digital Noise Mixer section instead of a CGS04 ; i need to confirm a few wiring things.
I'm a bit confused about which diagram to follow : the Muffs link below or the Wiring diagram from the CGS13 page.
* Which pad on the CGS 31 V1.2 Digital Noise Mixer section is Gated Comparator Mix Out ? Is it OUT as below to MIX OUT jack on the panel ?
* Which pad on the Noise Mixer does Gated Comparator CCW go to after it goes to Mix Inv Out jack on the panel via the 1K Resistor ?
*Should Range CCW be wired directly to a pad on the Noise mixer (ignoring the 1K resistor), then from OUT 1 to the INV OUT jack on the panel ?
* Which pad on the Noise Mixer does Gated Comparator CW go to ?
*Is the Range Pot wiper to be connected to the CW in all cases above ?
