Yahoo Groups archive

Cgs synth

Index last updated: 2026-04-28 23:16 UTC

Message

Re: Serge SSG problem.

2013-11-09 by Stephen Richards

Thanks D

The time difference is a bit killer and i started on my COA #3 today to get my mind off it all. I'll take some photos in the morning. In around 9 hrs or so. Maybe check back around 4 or 5pm Cali time.

If i can't upload pics to this forum , i might take it over to muffs. Or PM you.

cheers all


On Saturday, November 9, 2013 11:49 PM, Dmitri SFC <dankedout415@...> wrote:
The wire/jumper between L & S pads should make the bottom section seem like it doesnt work at all, until you feed it that high Coupler output (while patched to cycle).
When the L to S jumper is not installed the bottom section should Cycle at audio range like the top section does, making it a bit confusing at first.
Actually if you are wiring for COA #1 i would assume that you plan to use both sections as slews / no L to S jumper would be needed in that case.
With a photo we should be able to help. I only have the old board version here ( first CGS version) need to wire a COA#2 this week & need to order more PCBs ! :)
d

-


Attachments

  • No local attachments were found for this message.

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.