I was also planning to do just that. (The 1k resistance would just to quiet down the signal...?)
On the other side: If I wanted to put the gain of each band under CV control, is it realistic to do it with TL07x somewhere around the potentiometer? Or should I look at the vactroling solution?
Thanks.
On the other side: If I wanted to put the gain of each band under CV control, is it realistic to do it with TL07x somewhere around the potentiometer? Or should I look at the vactroling solution?
Thanks.
--- In cgs_synth@yahoogroups.com, sasami@... wrote:
>
> You would need to take each separate output from the output pins of the
> op-amps of each filter. The pots are on the INPUTS and thus are of no use as
> connection points. Put a 1k resistor between each output pin and its jack. I
> do not see there being any need for additional buffering, but I have not
> tried it.
>
> Ken
>
> >if i wanted to expose each of the individual frequency bands as individual
> outputs, could i just tap off the outputs normally going to the wiper pots
> (a,b,c,d,f,h,i,k,n,u) straight to panel jacks? or would i need to buffer
> each output? would it make a difference if i wanted to have both the
> individual outs and the standard mixing arrangement?
> >
> >
> >
> >------------------------------------
> >
> >The CGS Modular Synth home page: http://www.cgs.synth.net/
> >Yahoo! Groups Links
> >
> >
> >
> >
> _______________________________________________________________________
> Ken Stone sasami@... otherunicorn@...
> Modular Synth PCBs for sale <http://www.cgs.synth.net/>
> Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>
>